JBender

I have three different packages that have either arrived or are in the mail with much-needed parts for the Z. The break-down:

NissanParts.cc ~$190:

Throttle body gasket (x 2)
Oil filter tree gasket
Throw-out bearing
Pilot bushing
Steering joint
Clutch withdrawl pin
Brake booster hose


CarSteering.com $215 (+$100 core):

Remanufactured steering rack


Concept Z ~$600:

Energy Suspension Hyper-Flex Master Bushing kit (black)
Eibach Pro-Kit springs
300 Degree camber kit
Cargo cover hook (x 2)
New IAA connectors


I actually ordered the Concept Z parts a few weeks ago, but Coz had supplier problems with Energy Suspension, so those parts should be out in a few days.

Here's a picture of the contents of the NissanParts.cc box:



My reasons for replacing: the old brake booster hose was split on the ends. Steering joint was completely shot. Throttle bodies were sealed with liquid gasket instead of the paper gaskets. Old oil filter tree gasket was an oil leak suspect. The clutch parts are for the next time I go in there (forgot to order a rear main seal, oops).

The steering joint was the biggest purchase in this package, as my old one was toast after 199k miles and 17 years. Besides the normal movement on the axes, you could twist and move it any other way including horizontally along the bushings. This resulted in quite a bit of free play in the steering wheel. The installation wasn't difficult. Two 12mm bolts, and some prying to get the old one off. A comparison:



I also scraped off the liquid gasket and installed the new throttle body gaskets yesterday, which was a PITA with the plenum still on. I still have a slight vacuum leak from the bottom-left screw, most likely because I don't have the metal sheathe that goes in that screwhole. That part will be ordered shortly.

Replacing the oil filter tree gasket took a while but wasn't too tough. I cut the top off an empty milk jug (gallon) to catch the oil, because it is Mobil 1 with less than 400 miles on it (that would have been $24 down the drain otherwise). Then I removed the oil filter and sending unit, and pulled off the oil filter tree. The old gasket was caked on there quite a bit, and it took some time with a razor blade and some steel wool to bring the gasket surface back to a clean, even shine. Reinstallation was fairly simple, and I drove the car around for a few minutes. Still a few drops of oil underneath the car, so the main suspect is a faulty rear main seal (even though it was done over Spring Break).

Today, package 2 of 3 arrived. Physically, it's the biggest new part I've received, just beating the 1-piece driveshaft. The obligatory box shot:



And the beautiful 'new' rack inside:





I'll be installing the new rack once I receive the Concept Z parts, which include polyurethane steering rack bushings.

This is also a ZMods exclusive since I don't feel like cross-posting on 3ZC

__________________
"Purpose of site is to archive Z information. It is found by using search. Same reason you go to a library to read books to research a topic instead of standing in the library lobby shouting your question hoping someone has read the books your answer is in." - LordZ, TT.net